DIR-320 Wireless N150 Router with 3G/CDMA/LTE Support
and USB Port
User Manual
Configuring via Web-based Interface
To configure the router as a client, select the Enable client checkbox. When the checkbox is
selected, the following fields are displayed on the page:
Parameter Description
Broadcast wireless
network
If the checkbox is not selected, devices cannot connect to the router's
WLAN. Upon that the router can connect to another access point as
a wireless client.
Wireless network settings
SSID The name of the network to which the router connects.
BSSID
The unique identifier of the network to which the router connects.
Network Authentication The authentication type of the network to which the router connects.
When the Open or Shared authentication type is selected, the following fields are available:
Parameter Description
Enable Encryption WEP
The checkbox activating WEP encryption. When the checkbox is
selected, the Default Key ID field, the Encryption Key WEP as
HEX checkbox, the WEP key length drop-down list, and four
Encryption Key WEP fields are displayed on the page. For the
Shared authentication type the checkbox is always selected.
Default Key ID
The number of the key (from first to fourth) which will be used for
WEP encryption.
Encryption Key WEP
as HEX
Select the checkbox to set a hexadecimal number as a key for
encryption.
WEP key length
The length of WEP encryption key.
Select the value 64bit to specify keys containing 5 ASCII symbols
or 10 HEX symbols.
Select the value 128bit to specify keys containing 13 ASCII
symbols or 26 HEX symbols.
Encryption Key WEP (1-
4)
Keys for WEP encryption. The router uses the key selected from the
Default Key ID drop-down list. It is required to specify all the
fields.
Page 151 of 220
To Next Page
Loading...
