DIR-615 Wireless N300 Router
User Manual
Configuring via Web-based Interface
PPPoE + Static IP Connection
Figure 37. Configuring PPPoE + Static IP WAN connection.
Fill in the IP Address and Netmask fields.
In the Gateway IP address field, enter the IP address of the gateway used by this WAN
connection.
In the Primary DNS server field, enter the address of the primary DNS server.
As a rule, the specified settings are enough at this step to configure a connection of the selected
type. If you need to specify additional settings, open the expert settings mode. To do this, use the
switch in the bottom left corner of the page.
Page 49 of 208
To Next Page
Loading...
