D-Link DIR-619L User Manual

7D-Link DIR-619L User Manual
Section 2 - Installation
If you are connecting the router to a cable/DSL/satellite modem, please follow the steps below:
1. Place the router in an open and central location. Do not plug the power adapter into the router.
2. Turn the power o on your modem. If there is no on/o switch, then unplug the modem’s power adapter. Shut down your
computer.
3. Unplug the Ethernet cable (that connects your computer to your modem) from your computer and place it into the WAN
port on the router.
4. Plug an Ethernet cable into one of the four LAN ports on the router. Plug the other end into the Ethernet port on your
computer.
5. Turn on or plug in your modem. Wait for the modem to boot (about 30 seconds).
6. Plug the power adapter to the router and connect to an outlet or power strip. Wait about 30 seconds for the router to boot.
7. Turn on your computer.
8. Verify the link lights on the router. The power light, Internet light, and the LAN light (the port that your computer is plugged
into) should be lit. If not, make sure your computer, modem, and router are powered on and verify the cable connections
are correct.
9. Skip to page 8 to congure your router.
Connect to Cable/DSL/Satellite Modem

D-Link DIR-619L Specifications

General

Frequency Band	2.4 GHz
LAN Ports	4 x 10/100 Mbps
WAN Ports	1 x 10/100 Mbps
Wireless Speed	Up to 300 Mbps
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Wireless Standard	IEEE 802.11b/g/n
Security	WPA, WPA2
Operating Temperature	0 to 40 °C
Storage Temperature	-20 to 65 °C
Antenna Type	3 x 5dBi External Antennas