DIR-815 Quick Installation Guide
Con#guring Wired WAN Connection
This configuration step is available for the Router and WISP Repeater
modes.
!
You should configure your WAN connection in accordance with data
provided by your Internet service provider (ISP). Make sure that you
have obtained all necessary information prior to configuring your
connection. Otherwise contact your ISP.
1. On the Internet connection type page, manually select the needed
value from the Connection type list.
Static IPv4: Fill in the following fields: IP address, Subnet mask,
Gateway IP address, and DNS IP address.
Static IPv6: Fill in the following fields: IP address, Prefix, Gateway
IP address, and DNS IP address.
30
To Next Page
Loading...
