DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh Router
User Manual
Configuring via Web-based Interface
In the DHCP Options section, you can change default values for some options of DHCP protocol
(IP address, subnet mask, DNS servers) or specify additional parameters which the built-in DHCP
server should send to clients to configure the local network.
Figure 89. Configuring the local interface. The IPv4 tab. The section for configuring DHCP options.
To do this, click the ADD button ( ).
Figure 90. Configuring the local interface. The IPv4 tab. The window for configuring a DHCP option.
In the opened window, you can specify the following parameters:
Parameter Description
Known DHCP options
From the drop-down list, select an option which you want to
configure.
Options value
Specify the value for the selected option.
Force
Move the switch to the right to let the DHCP server send the
selected option regardless of the client's request.
Move the switch to the left to let the DHCP server send the selected
option only when the client requests it.
After specifying the needed parameters, click the APPLY button.
To edit the parameters of an option, left-click the relevant line in the table. In the opened window,
change the needed parameters and click the APPLY button.
To remove the value of an option, select the checkbox located to the left of the relevant line in the
table and click the DELETE button ( ). Then click the APPLY button.
If needed, you can add your own address resource records. To do this, click the ADD button ( )
in the Hosts section (available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard).
Page 106 of 235
To Next Page
Loading...
