DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh Router
User Manual
Configuring via Web-based Interface
3. Make sure the connection is successful. To do this, in the web-based interface of the main
device, on the Wi-Fi / EasyMesh page, in the Network topology section, check the
information on the connected devices.
Connecting Subordinate Devices via Web-based Interface
To connect a subordinate device with the ESTABLISH CONNECTION button in the web-based
interface, follow the next steps:
1. Simultaneously press the ESTABLISH CONNECTION button in the web-based interface
the main and the subordinate device (or two subordinate devices, if one of them has
previously been connected to the mesh network).
!
Do not press the button on more than two devices simultaneously.
2. The DIR-822 WPS LED should start blinking. Wait for about 4 minutes for the subordinate
device to receive all mesh network settings and web-based interface password from the main
device.
3. Make sure the connection is successful. To do this, in the web-based interface of the main
device, on the Wi-Fi / EasyMesh page, in the Network topology section, check the
information on the connected devices.
To view detailed data on a mesh network device, click the line corresponding to this device in the
Network topology section.
Figure 115. The device information page.
Page 146 of 235
To Next Page
Loading...
