DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh Router
User Manual
Configuring via Web-based Interface
Creating PPTP, L2TP, or L2TP over IPsec WAN Connection
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 78. The page for creating a new PPTP connection. The General Settings section.
Parameter Description
General Settings
Connection name
A name for the connection for easier identification.
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
NAT
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
Ping
For the PPTP and L2TP types only.
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
Page 92 of 235
To Next Page
Loading...
