D-Link DNR-322L

Installation
Step 1:
Connect the included Ethernet cable to the Ethernet port located on the back
panel of the DNR-322L and attach it to your network.
Step 2:
Connect the power supply to the power connector located on the back panel of
the DNR-322L and connect it to a wall outlet or power strip. Power is conrmed
when the blue LED Power Indicator located on the front panel is lit.
Step 3:
Open your web browser and go to http://www.mydlink.com/support. Then, click
the Storage tab and select your product to download the Setup Wizard.
Windows users - Extract the les and run Setup.exe.
Mac users - Open the SetupWizard le and launch the Wizard.
Step 4:
Click the Start button to start the wizard and follow the instructions to set up your
NVR. If you want to add cameras to your previously-configured DNR-322L, click
the Skip button.
Note: Ensure that cameras have been installed on the network before initiating the
DNR-322L setup.
4