Filename: PRVFAQ.DOC
Copyright 1998, D-Link Corp. For D-Link Internal Use Only2
b. Reset the Print Servers (for login)
c. reload “ipxrtr”
5. Is there any additional service or utility that need to be added in Windows95 to run and configure
for the Print Servers NetWare protocol in PS Admin program?
It is necessary to install “Client for NetWare” on the platform which
system you want to run PS Admin to configure Print Servers for NetWare protocol. Because, PS Admin
need supervisor’s right to configure system. Please also see in our user guide.
It is necessary to install "Client for NetWare" on the platform which
system you want to run PS Admin to configure.
6. How many Unix Systems that D-Link Print Servers support?
D-Link Print Servers have been tested with the following Unix System.
*HP-UNIX
*SCO UNIX
*Solaris
*SunOS
*IBM AIX
*Unix Ware
*DEC UNIX
*Linux
*AT&T UNIX
*BSD/OS
*FreeBSD
*NetBSD
7. Does D-Link Print Servers support DHCP server?
No, D-Link Print Servers support the DHCP client. But
we strongly recommended disabling Print Server’s DHCP protocol or
configuring a fixed IP address for Print Server.
8. Why did we find that Print Server’s ARP IP assignment not work, why?
The ARP IP assignment assign IP to new Print Server with default setting and then
use Telnet to do some setting for Print Server. If Print Server has been set,
you should be done the “Factory Reset” and tries to do ARP IP assignment. Please save a copy for your
setting before do factory reset is requirement
9. How PS-Admin program works on pure NetBEUI Win95/WinNT environment?
You have to load IPX/SPX protocol on your Win95/WinNT network section before running PS-
Admin program.
- End of this document -
To Previous Page
Loading...
Need help?
General
