EasyManua.ls Logo

D-Link DPH-120SE - Page 31

D-Link DPH-120SE
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAC Address The current MAC address of the phone.
Current IP Gateway The current Gateway IP address.
Please select the proper network mode according to the network condition.
DPH-120S/DPH-120SE provide three different network settings:
Static: If your ISP server provides you the static IP address, please select
this mode, and then finish Static Mode setting. If you don’t know about
parameters of Static Mode setting, please ask your ISP for them.
DHCP: In this mode, you will get the information from the DHCP server
automatically; need not to input this information artificially.
PPPoE: In this mode, you must input your ADSL account and password.
You can also refer to2.2.1 Network settingto speed setting your network.
Obtain DNS server
automatically
Select it to use DHCP mode to get DNS address, if
you don’t select it, you will use static DNS server. The
default is selecting it.
If you use static mode, you need set it.
IP Address Input the IP address distributed to you.
Subnet Mask Input the Netmask distributed to you.
IP Gateway Input the Gateway address distributed to you.
DNS Domain
Set DNS domain postfix. When the domain which
you input cannot be parsed, phone will automatically
add this domain to the end of the domain which you
input before and parse it again.
Primary DNS Input your primary DNS server address.
Secondary DNS Input your standby DNS server address.
If you uses PPPoE mode, you need to make the above setting.
Service Name It will be provided by ISP.
User Input your ADSL account.
Password Input your ADSL password.
Notice:

Table of Contents

Related product manuals