8 Web configuration
8.1 Introduction of configuration
8.1.1 Ways to configure
DPH-400S/DPH-400SE has three different ways to different users.
Use phone keypad.
Use web browser (recommendatory way).
Use telnet with CLI command.
8.1.2 Password Configuration
There are two levels to access to phone: root level and general level. User with
root level can browse and set all configuration parameters, while user with
general level can set all configuration parameters except SIP (1~5) ’s that some
parameters cannot be changed, such as server address and port. User will has
different access level with different username and password.
Default user with general level：
username：guest
password：guest
Default user with root level：
username：admin
password：admin
The default password of phone screen menu is 123.
8.2 Setting via web browser
When this phone and PC are connected to network, enter the IP address of the
wan port in this phone as the URL (e.g. http://xxx.xxx.xxx.xxx/ or
http://xxx.xxx.xxx.xxx:xxxx/).
If you do not know the IP address, you can look it up on the phone’s display by
checking menu-Status.
The login page is as below picture
To Next Page
Loading...
