DSL-500G ADSL Router User’s Guide
Hub or Switch to Router Connection
Connect the Router to an uplink port (MDI-II) on an Ethernet hub or switch with a straight-through cable as
shown in the diagram below:
If you wish to reserve the uplink port
on the switch or hub for another
device, connect to any on the other
MDI-X ports (1x, 2x, etc.) with a
cross-wired cable or use crossover
adapter.
Figure 4. Switch to Router Connection
Power On Router
To power on the device:
1. Insert the AC Power Adapter cord into the power receptacle located on the back of the Router and plug the
adapter into a nearby power source.
2. You should see the Power LED indicator light up and remain lit.
4
To Next Page
Loading...
