D-Link DSR-1000N - IGMP Setup

Unified Services Router CLI Reference Guide
33
Sl No
Command Name
Description
Type and Description
8
loadbalancing
failover_method dns
ipaddr_wan3
Set WAN3 DNS IP
Valid ip address,
valid wan3 dns ip n load balancing
mode
9
loadbalancing
failover_method ping
ipaddr_wan1
Set WAN1 PING IP
Valid ip address,
valid wan1 ip in load balancing
mode
10
loadbalancing
failover_method ping
ipaddr_wan2
Set WAN2 PING IP
Valid ip address,
valid wan2 ip n load balancing
mode
11
loadbalancing
failover_method ping
ipaddr_wan3
Set WAN3 PING IP
Valid ip address,
valid wan3 ip n load balancing
mode
12
loadbalancing
failover_method retry_interval
Set retry time
Valid value is between 5 to 999
13
loadbalancing
failover_method
retry_attempts
Set failover attempts
Valid value is between 2 to 999
14
rollover wan_port
Select the Auto rollover WAN port as
a primary wan
Set Primary WAN Type options
from wan1 or wan2 or wan3
15
rollover wan_port_Sec
Select the Auto rollover WAN port as a
secondary wan
Set Secondary WAN Type options
from wan1 or wan2 or wan3
16
rollover failover_method type
Select the Fail Over detection method
"Set detection Type from None(0)
DNS-lookup-Using-WAN-DNS(1)
DNS-lookup-Using-CUSTOM(2)
Ping-IP-Addresses(3)
17
rollover failover_method dns
ipaddr_wan1
Set WAN1 DNS IP
Valid ip address,
valid wan1 dns ip n rollver mode
18
rollover failover_method dns
ipaddr_wan2
Set WAN2 DNS IP
Valid ip address,
valid wan2 dns ip n rollver mode
19
rollover failover_method dns
ipaddr_wan3
Set WAN3 DNS IP
Valid ip address,
valid wan3 dns ip in rollver mode
20
rollover failover_method ping
ipaddr_wan1
Set WAN1 PING IP
Valid ip address,
valid wan1 ip in rollver mode
21
rollover failover_method ping
ipaddr_wan2
Set WAN2 PING IP
Valid ip address,
valid wan2 ip in rollver mode
22
rollover failover_method ping
ipaddr_wan3
Set WAN3 PING IP
Valid ip address,
valid wan3 ip in rollver mode
23
rollover failover_method
retry_interval
Set retry time
Valid value is between 5 to 999
24
rollover failover_method
retry_attempts
Set failover attempts
Valid value is between 2 to 999
25
singleport wan_port
Set WAN Type which you want to
choose
Select from wan1 or wan2 or wan3
26
Cancel
Roll back upnp configuration changes
27
exit
Save upnp configuration changes and
exit current mode
28
save
Save upnp configuration changes