D-Link DSR-1000N - Routing Mode; NAT or Classical

Unified Services Router CLI Reference Guide
58
Sl No
Command Name
Description
Type and Description
8
exit
Save access Management changes for
https and exit current mode.
9
cancel
Roll back Remote Mgmt changes.
10.7 system snmp sys configure
Sl No
Command Name
Description
Type and Description
1
contact <contact>
Set system contact information.
String,
System contact identifier
2
location <location>
Set system location information.
String,
System location identifier
3
name <name>
Set system name information.
String,
System name identifier
4
cancel
Roll back snmp configuration changes.
5
save
Save SNMP system configuration
changes.
6
exit
Save SNMP system configuration
changes and exit current mode.
10.8 system snmp trap configure <agentIp>
Sl No
Command Name
Description
Type and Description
1
agent <ip_address>
The IP address of the SNMP agent.
IP address AAA.BBB.CCC.DDD
where each part is in the range 0-
255
2
community <community>
The community string to which the
agent belongs. Most agents are
configured to listen for traps in the
Public community
String,
Community name
3
port <port>
SNMP trap port the trap messages will
be sent to.
Port number (0..65535)
4
subnet_mask <IPAddress>
The network mask used to determine
the list of allowed SNMP managers. To
allow any IP on the network to manager
the dev
IP address AAA.BBB.CCC.DDD
where each part is in the range 0-
255
5
cancel
Roll back snmp configuration changes.
6
exit
Save SNMP trap configuration
changes and exit current mode.
7
save
Save SNMP trap configuration
changes.
10.9 system snmp trap delete <agentIp>
Sl No
Command Name
Description
Type and Description
1
agentIp
The IP address of the SNMP agent.
IP address AAA.BBB.CCC.DDD