EasyManua.ls Logo

D-Link DSR-500N - Vpn Sslvpn Users Users Delete <Ltrow_Id; Vpn Ipsec Policy Configure <Ltname

D-Link DSR-500N
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Unified Services Router CLI Reference Guide
121
12.35 vpn sslvpn users users delete
<ltrow_id>
S.No
Command Name
Description
Type and Description
1
<ltrow_id>
Users delete mode
Unsigned integer
12.36 vpn ipsec policy configure <ltname>
S.No
Command Name
Description
Type and Description
1
<ltname>
vpn policy configuration mode
String
2
save
Save vpn policy configuration changes.
3
cancel
Roll back vpn policy configuration
changes.
4
exit
Save vpn policy configuration changes
and exit current mode.
5
general_policy_type
Setting policy manual or auto
vpn policy type
6
general_ike_version
Setting version ikev1 or ikev2
IPsec VPN IKE Version
7
general_ip_protocol_version
Setting protocol version ipv4 or ipv6
vpn protocol version
8
general_ipsec_mode
Setting ipsec mode for the vpn policy
VPN ipsec modes
9
general_select_local_gateway
Setting local gateway for the vpn policy
VPN gatew ay
10
general_remote_end_point_type
Set mode to IP address or Internet
Name/FQDN of the remote gatew ay or
client PC
vpn remote end point type
11
general_remote_end_point
The IP address or Internet Name/FQDN
of the remote gatew ay or client PC.
12
general_remote_end_point ip_address
The IP address of the remote gatew ay or
client PC.
IPV4 or IPv6 address
depending upon protocol
selected IPV4 or IPV6
13
general_remote_end_point fqdn
The IP address or Internet Name/FQDN
of the remote gatew ay or client PC.
String
14
general_enable_mode_config
enable/disable mode config
Boolean choice
15
general_enable_netbios
enable/disable this to allow NetBIOS
broadcasts to travel over the VPN tunnel.
Boolean choice
16
general_enable_rollover
enable/disable rollover
Boolean choice
17
general_protocol
Setting protocol esp or ah
IPsec VPN Protocol
18
general_enable_dhcp
enable/disable dhcp.
Boolean choice
19
general_local_netw ork_type
Select the IP addresses on the local side
that w ill be part of the tunnel. This can be
either a single IP address, several IP
addresses in a range, an entire subnet,
or any IP address that w ants to connect
vpn network type
20
general_local_start_address
IP address from w here the range needs
to begin
IPV4 or IPv6 address
depending upon protocol
selected IPV4 or IPV6
21
general_local_end_address
IP address w here the range needs to
end
IPV4 or IPv6 address

Table of Contents

Other manuals for D-Link DSR-500N

Related product manuals