D-Link DSR-500N - Net Wan Port_Setup Configure; Net Wan Configurable_Port Configure; Net Wan Wan1 Ipv6 Configure

Unified Services Router CLI Reference Guide
59
w here each part is in the range 0-
255
34
rollover failover_method ping
ipaddr_w an3
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
35
rollover failover_method
retry_interval
idle timeout value type.
36
rollover failover_method
retry_attempts
number in range of 2 to 999
37
singleport
38
singleport w an_port
WAN interface type
8.34 net wan port_setup configure
S.No
Command Name
Description
Type and Description
1
save
Save WAN port settings.
2
exit
Save WAN port settings and exit current
mode.
3
cancel
Roll back WAN port settings changes.
4
respond_ping
Disable or Enable ping on WAN side
Boolean choice
5
w an1
WAN1 port settings
6
w an1 mtu_type
Enter MTU type
mtu type
7
w an1 mtu_size
Enter MTU size for WAN1
mtu size
8
w an1 port_speed
Enter the type of port speed for WAN1
Port Speed types
9
w an2
WAN2 port settings
10
w an2 mtu_type
Enter MTU type
mtu type
11
w an2 mtu_size
Enter MTU size for WAN2
mtu size
12
w an2 port_speed
Enter the type of port speed for WAN2
Port Speed types
8.35 net wan configurable_port configure
S.No
Command Name
Description
Type and Description
1
save
Save Configurable WAN settings.
2
exit
Save configurable WAN settings and exit
current mode.
3
cancel
Roll back Configurable WAN settings
changes.
4
port_name
Select the configurable port type
WAN interface type
8.36 net wan wan1 ipv6 configure
S.No
Command Name
Description
Type and Description
1
save
Save ipv6 w an1 configuration changes.
2
cancel
Roll back ipv6 w an configuration
changes.
3
exit
Save ipv6 w an1 configuration changes
and current mode.