D-Link DSR-500N - Page 30

Unified Services Router CLI Reference Guide
28
The command dot11 ? at the CLI prompt would give the description of all the configuration
commands in the branch dot11, which is as follows :
Sl No
Command Name
Pur pose
1
dot11 access point configure
802.11 access point configuration mode
2
dot11 access point delete
Delete an 802.11 access point.
3
dot11 access point disable
Disable an 802.11 access point.
4
dot11 access point enable
Enable an 802.11 access point.
5
dot11 access point mac add
Add a MAC Address to ACL List of an AP
6
dot11 access point mac delete
Delete a MAC Address from an ACL List of an AP.
7
dot11 radio advanced configure
802.11 advanced radio configuration mode.
8
dot11 radio configure
802.11 radio configuration mode.
9
dot11 profile configure
802.11 profile configuration mode.
10
dot11 profile delete
Delete an 802.11 profile.
The command radius ? at the CLI prompt would give t he description of all the configuration
commands in the branch radius , which is as follows:
Sl No
Command Name
De s cription
1
radius configure <ltradius_server>
RADIUS configuration mode.
2
radius delete <ltradius_server>
Delete a RADIUS configuration mode.
Each of the above listed commands has in turn a set of sub -commands to fulfill the
requirements. The command – subcommand list is given in following s ections.