D-Link DUB-E100 Quick Installation Guide

2
Connecting the DUB-E100 to Your
Computer
Plug the DUB-E100’s USB cable
into an available USB port on your
computer.
Windows will detect new hardware
and prompt you for the drivers.
Follow the steps below and then
proceed to the Driver Installation
section on the following pages.
Attach an Ethernet cable to the
Ethernet port on the DUB-E100.
Attach the other end of the Ethernet
cable to your network switch, hub,
or router.

D-Link DUB-E100 Specifications

Power

bus power	2.5 W
current	0.5 A
voltage	5 V DC

Operating Environment

operating temperature	0 ˚ to 40 ˚C
storage temperature	-10 ˚ to 70 ˚C
operating humidity	5% to 95% (non-condensing)

Ports & interfaces

usb port	USB Type A
ethernet port	RJ-45 (10/100 Mbps Dual-Speed)
diagnostic LEDs	Speed, Tx/Rx Traffic

Weight and Dimensions

dimensions	73 x 21.3 x 20 mm
weight	22 g