22
Linux 2.6.x
To verify if the DUB-E100 driver is properly installed:
1. Load the DUB-E100 module by the following command:
[root@localhost linux2.6.14_rev101]# modprobe asix
2. List the loaded modules with the specied pattern “asix”:
[root@localhost linux2.6.14_rev101]# lsmod | grep asix
Then you should get the reply similar to the following lines:
asix 26880 0
usbnet 20616 1 asix
mii 9600 2 asix,e100
usbcore 114896 5 asix,usbnet,usb_storage,echi_hcd,uhci_hcd
If you still have problem on installing the D-Link USB DUB-E100 driver, please contact D-Link
Technical Support.
To Next Page
Loading...
