D-Link DWR-910 User Manual

Technical Support Setup Procedure
Page 1 of 3
How to perform firmware upgrade of DWR-910?
Note: By default, the network name(SSID) of the DWR-910 will be in the format
dlink_DWR_910_xxxx where “xxxx” represents the last 4 characters of the
DWR-910’s MAC Address. Please find the default SSID and password on the
product label pasted on the device.
Step 1 Ensure that the device is turned on and the desired SSID is found in the list
of Wireless Networks on your Wireless Computer.
Step 2 Select the DWR-910’s Wireless Network Name. Click on Connect as shown.
Step 3 Please key in the corresponding WiFi Key as found on the label. Click OK to
proceed.

D-Link DWR-910 Specifications

General

Device Type	Wireless Router
Wireless Standard	802.11n
Maximum Wireless Speed	150 Mbps
WAN Ports	1
LAN Ports	4
Cellular Technology	4G LTE
SIM Slot	Yes
Antenna Type	External
Security	WPA/WPA2

Summary

DWR-910 Firmware Upgrade Guide

Connect to DWR-910 Wi-Fi Network

Find and connect to the device's default Wi-Fi network SSID and password from the label.

Access DWR-910 Web Interface

Launch a web browser and navigate to the device's IP address to log in with default credentials.

Navigate to Firmware Upgrade Section

Access the System tab and then select the Firmware Upgrade option from the left-hand side.

Select and Upload Firmware File

Browse for the downloaded firmware file and initiate the upload process by clicking Open.

Apply Firmware and Restore Defaults

Tick the option to restore factory configuration after upgrading and click Apply.

Monitor Upgrade and Reboot

Wait for the firmware upload and device reboot process to complete without interruption.

Confirm Upgrade Completion

Click OK to acknowledge the successful firmware upgrade and completion message.