D-Link DWR-925 - Powering the Router; Connecting Devices

D WR-925
10
ENGLISH
Powering the Router
The router requires 12 volt power supply and a minimum of 1
amp.
Using the Included AC Adapter
1. Attach the barrel connector of included AC adapter to the
DWR-925 power port on the rear panel.
2. Attach the AC adapter to an appropriate AC socket.
Connecting Devices
After the DWR-925 has been successfully installed, the router can
be connected to the end device via the following connection
methods:
Over Ethernet
The Ethernet port can be connected to an end device. Use a
standard Category 5/5e/6 RJ-45 Ethernet cable to connect the
end device to the router. The port will auto-negotiate to the
highest possible port speed based on the connected device.
Note that the DWR-925 supports a maximum transfer speed of
100 Mbps over Ethernet.
Over Wi-Fi
You can connect to the router using the SSID and security settings
listed on the bottom of the router. If your Wi-Fi has previously
been congured, use those settings instead. The router supports
up to 802.11n speeds on the 2.4 GHz network. Maximum tranfer
speeds are dependent on network conditions.