D-Link Eagle Pro Al R12 - Page 44

39D-Link R12 User Manual
Section 3 - Conguration
Advanced Settings... - Address Autoconguration Settings
Enable Automatic
IPv6 Address
Assignment
Enable or disable the Automatic IPv6 Address Assignment
feature.
Enable Automatic
DHCP-PD in LAN
Enable or disable DHCP-PD for other IPv6 routers connected to
a LAN interface. This option is only available if Enable DHCP-PD
is enabled in the previous LAN IPv6 Address Settings.
Autoconguration
Type
Select SLAAC+RDNSS, SLAAC+Stateless DHCP, or Stateful
DHCPv6.
If you select SLAAC+RDNSS or SLAAC+Stateless DHCP as the Autoconguration Type:
Router
Advertisement
Lifetime
Enter the router advertisement lifetime (in minutes). The
default is 30 minutes.
If you select Stateful DHCPv6 as the Autoconguration Type:
IPv6 Address
Range (Start)
Enter the start IPv6 address for the DHCP server’s IPv6
assignment.
IPv6 Address
Range (End)
IPv6 Address Lifetime
Enter the end IPv6 address for the DHCP server’s IPv6
assignment.
Enter the dynamic IP's retention time. The default is 10080
minutes.