D-Link Eagle Pro Al R12 - Page 73

68D-Link R12 User Manual
Section 3 - Conguration
This Quality of Service (QoS) Engine allows you to prioritize particular
clients over others, so that these clients receive higher bandwidth. For
example, if one client is streaming a movie and another is downloading a
bulk of les, you might want to assign the former device a higher priority
than the latter so that the movie streaming is not disrupted.
Under Connected Clients, you will see device cards representing each
connected client.
To assign a priority level to a device, enable AI Trac Optimizer rst and
save your settings. Then click the client to open its information page. It
shows the following information:
Device Name: The name that describes the client device.
MAC Address: The MAC address of the client device.
IPv4/IPv6 Address: The IP address in IPv4 and IPv6 addressing mechanism
of the client device.
Priority: Select the priority for the client device with the following
categories:
Normal; High: Always Enable, for 1 Day, for 4 Hours, for 2 Hours, or for
1 Hour; Low: Always Enable, for 1 Day, for 4 Hours, for 2 Hours, or for 1
Hour.