D-Link GO-SW-5G Quick Installation Guide

GO-SW-5G & 8G
4
ENGLISH
TROUBLESHOOTING
SETUP AND CONFIGURATION PROBLEMS
1. WHAT TO DO IF THE POWER LED IS NOT LIT UP?
Check if the power adapter is properly connected to a wall socket and the back of the
GO-SW-5G & 8G .
2. WHAT TO DO IF A CONNECTED DEVICE IS NOT DETECTED?
First check if the Port LED is ashing. If the Port LED is not illuminated, try connecting the device
using a different LAN cable.
TECHNICAL SUPPORT

D-Link GO-SW-5G Specifications

General

Switching Capacity	10 Gbps
MAC Address Table Size	2K entries
Jumbo Frame Support	9, 216 bytes
Fanless Design	Yes
Data Transfer Rate	10/100/1000 Mbps
Ports	5 Gigabit Ethernet ports
Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Power Consumption	2.5 Watts max