8
DNR-202L Install Guide
Accessing the NVR
*Note: In order to connect to the DNR-202L using this method, you MUST be connected to the
same network as the device.
*Note: You will be prompted to enter your username and password. The default username is admin
and the password will have been congured by you during step 8 of the initial setup.
1
2
Open your web browser (e.g., Internet Explorer, Firefox, Safari) and enter the IP
address of your DNR-202L into the address bar. The IP address can be found during
the setup wizard (step 7 on page 6).
You are now logged into your DNR-202L.
Alternatively, you can use the mydlink portal to remotely connect to the DNR-202L
over the Internet if you added the DNR-202L to your mydlink account during the
initial setup.
Select your DNR-202L and click the Connect button.
Go to www.mydlink.com and log into your account.
To Next Page
Loading...
