D-Link mydlink DSP-W215 User Manual

11D-Link DSP-W215 User Manual
Section 2 - Installation
Manual Setup
If you tapped Manual in Step 8, you must connect to the Smart Plug
directly. Do not close this app.
On your device, go to Settings > Wi-Fi. Select the network called
DSP-xxxx (where xxxx is the last 4 digits of the MAC address).
Note: For the exact network name (SSID), refer to the Quick Install card that
came with the product.
Tap Next to continue.
The app may ask if you wish to connect to your current Wi-Fi. Tap Yes
or No.
Enter the PIN code and tap Next.
This code is located both on the back of the Smart Plug and the Quick
Install card.

D-Link mydlink DSP-W215 Specifications

Power

input voltage	100 to 240 V
power consumption	Maximum 5 W

Operating Environment

operating temperature	0 to 40 °C (32 to 104 °F)
storage temperature	-20 to 65 °C (-4 to 149 °F)
operating humidity	10% to 90% non-condensing
storage humidity	5% to 95% non-condensing

Weight and Dimensions

dimensions	117 x 66 x 39 mm (4.6 x 2.6 x 1.55 inches)
weight	125 grams (4.41 ounces)