28D-Link WBR-1310 User Manual
Section 3 - Configuration
Port Forwarding Rules
This will allow you to open a single port or a range of ports.
Check the box to enabled the rule.
Enter a name for the rule.
Enter the IP address of the computer on your
local network that you want to allow the incoming
service to.
Enter the port or ports that you want to open.
If you want to open 1 port, enter the same port
in both boxes.
Select TCP, UDP, or ANY.
Rule:
Name:
IP Address:
Start Port/
End Port:
Traffic Type:
To Next Page
Loading...
Need help?
General
