Need help?Do you have a question about the Dacor DCM24S and is the answer not in the manual?
General| Capacity | 2.0 cu. ft. |
|---|---|
| Installation Type | Countertop |
| Control Type | Electronic |
| Finish | Stainless Steel |
| Fuel Type | Electric |
| Color | Stainless Steel |
| Voltage | 120 V |
| Frequency | 60 Hz |
| Power | 1, 000 W |
| Width | 24 in |
| Power Output | 1000 watts |
| Type | Built-in Microwave Oven |
Procedure for checking microwave emissions before service.
Steps for before and after service, including safety.
Steps for leakage testing, including requirements and setup.
Overview of models, manual purpose, and study recommendations.
Safety precautions and hazardous component identification.
Details on oven functions, issue resolution, and component testing.
Information on control panel, parts, and diagrams.
Oven specifications and grounding instructions.
Illustrations showing physical layout of components and controls.
Explains sequences for off, cooking, power levels, and convection.
Details mixed cooking, sensor cooking, and their procedures.
Auto programs, defrost, and the oven's fire sensing feature.
Electrical schematics for off and microwave cooking states.
Electrical schematics for mix and convection cooking.
Functionality of door switches for safety and operation.
Functions of various safety, heating, and airflow components.
Key steps for diagnosing issues and safety during troubleshooting.
Linking problems to causes, conditions, and outlining test procedures.
Procedures for testing the magnetron and power transformer.
Procedures for testing high voltage components and interlock switches.
Procedures for testing relays, monitor switch, and blown fuse.
Procedures for testing fuses, thermal cut-out, and heating element.
Procedures for testing the thermistor, damper motor, and switch.
Procedures for checking convection temperature and control panel.
Test procedure for the key unit of the control panel.
Procedures for testing relays, auto defrost, and PWB foil patterns.
Test procedure for the AH sensor.
Tests for sensor cooking, AH sensor, and control unit.
Procedure to check the control unit's functionality.
Overview of panel components and LSI functions.
Details LSI signals for display voltage and power source input.
Details LSI signals for control, timing, and indicators.
Details LSI signals for key matrix input and digit selection.
Description, operation, and detector circuit for the humidity sensor.
Precautions for handling components and servicing the touch panel.
Required tools and further precautions for control unit servicing.
Critical warnings about high voltage and wiring safety.
Step-by-step guide for removing the oven's outer case.
Procedures for removing power transformer, magnetron, rectifier, capacitor.
Procedures for removing convection motor, turntable motor, damper, lamp.
Procedures for removing heater unit, heating element, and fan motor.
Procedure for removing control panel, control unit, and key unit.
Adjustment procedure for door sensing, interlock, and monitor switches.
Adjusting door switches and overall door alignment.
Procedures for removing choke cover, panel, glass, and decoration.
To Next Page
