Dacor ER30D Installation Instructions

Dacor●600AntonBlvd.Suite1000CostaMesa,CA92626●Phone:(800)793-0093●Fax:(626)403-3130●www.Dacor.com
STEP 16: Remove the two (2) torx screws from the bottom of the
handle.
STEP 17: Pull the end caps off the end of the handle and replace
them with the new ones.
STEP 18: Thread the two (2) torx head screws into the handle and
tighten them into place. CAUTION: Do not overtighten.
Tighten only by hand.
STEP 19: Line up the screw holes on the handle with the mounting
holes on the oven door. Make sure the screws that hold the
end caps in place face toward the bottom of the door.
STEP 20: Thread the two (2) screws through the door and into
the handle. Tighten them into place. Do not overtighten.
Damage to the door or the door glass may result.
STEP 21: On model ER36D: Replace the screw covers.
STEP 22: Remove the clamps or tape from the door.
Handle
Screw,
2 places
End Cap,
2 places

Dacor ER30D Specifications

General

Brand	Dacor
Model	ER30D
Category	Ranges
Language	English