7
-44
DK35(CH)SE/DK40(CH)SE/DK45(C)HSE
H11O671AH11O670A
TURN SIGNAL LAMP (FRONT)
(1) Turn Signal Lamp (RR) Bulb
3. Remove the bulb by turning its socket
counterclockwise. Install a new bulb.
(1) Turn Signal Lamp (FRT)
(2) Mounting Bolt
(3) Turn Signal Lamp (FRT) Bulb
1. Remove the cap and unscrew the
mounting bolts to remove the front
turn signal lamp assembly.
2. Turn the bulb body counterclockwise
to remove it.
3. Remove the bulb by pressing it down
lightly and install a new bulb. Fit the
socket to the grooves and turn it
clockwise.
Do not touch the bulb if it is still
illuminated or right after it is
turned off. You can be burnt by
the hot bulb.
For some bulbs which require
delicate handling or work
process, contact your local
KIOTI Dealer.
Do not touch the illuminating
glass part of the halogen bulb.
The bulb life can be shortened
by finger prints, dust and
moisture, or the bulb even can
be broken. Clean it with soft
cloth.
The halogen bulb contains com-
pressed gas, so it can explode
if dropping or scratching it.
Therefore, never use a bulb if it
is scratched or was dropped.
!!
!!
!
CAUTION
To Next Page