4
-34
DK35(CH)SE/DK40(CH)SE/DK45(C)HSE
(1) Draft Control Lever (2) Stop Bolt
H11O473A
DRAFT CONTROL LEVER(IF
EQUIPPED)
The draft function can be used for the
plow which is installed to the lower link
(lifting arm).
If the plow is applied with excessive
draft, the lifting arm is automatically
raised to reduce the draft and then re-
turned to its original. This is called as
“Draft Function”.
The plowing depth can
be controlled by the soil status by put-
ting the draft control lever into the “Deep”
position to activate the draft function at
mid load and putting the lever into the
The position control lever is used to
keep the plowing depth constant dur-
ing work.
The implement attached to the lifting
arm can be lowered by pushing the le-
ver while the implement is raised by
pulling the lever.
In order to limit the lowering height of
implements, use the lock bolt (2) to limit
the operating range of the lever.
For detailed information, refer to “Initial
Operation” in Chapter 5.
H23O4F0A
POSITION CONTROL LEVER
(1) Position Control Lever (3) Lower Link
(2) Lock Bolt
(A) Lowering (B) Lifting
To Next Page
Loading...
