DAELIM CORDI

Vehicle designed for two riders, including the operator.

Motorcycle intended for road use only.

Emphasizes paying special attention to warnings and cautions.

Details service intervals, safe maintenance procedures, and tool kit contents.

Steps before driving, operation methods, turning, braking, and wiring diagrams.

Technical data and dimensions of the motorcycle.

Guidance on using the manual, vehicle features, and general safety advice.

Essential pre-operation checks and recommended riding attire.

How to operate smoothly, safely, and guidelines for carrying cargo.

Warnings against modifications, advice on attachments, and muffler precautions.

Diagram identifying key motorcycle components.

Explanation of speedometer, odometer, and fuel gauge.

Meanings of warning lights and indicators.

How to use the ignition and steering lock.

Procedure for starting the engine using the starter button.

Procedure to activate the headlight and use high/low beams.

How to operate the turn signals.

Operation of the horn and securing handlebars to prevent theft.

How to lock and unlock the seat.

Information about the luggage carrying hook.

Details about the storage compartment under the seat.

Location for storing manuals and related documents.

How to engage and disengage the brake lock lever.

Procedures and precautions for starting the engine.

Steps to take after the engine has successfully started.

Troubleshooting steps if the engine fails to start.

Techniques for smooth and safe acceleration and deceleration.

Procedures for safely bringing the vehicle to a halt.

Daily checks to ensure the vehicle is safe to ride.

Checking specific areas noted from previous use.

How to check the fuel level and instructions for adding fuel.

Procedures for checking tire pressure, condition, and tread.

Checking and adjusting brake lever play.

How to inspect the brake fluid level.

Procedures for checking engine oil and fuel leaks.

Inspection of lighting, turn signals, and mirrors.

Verifying the condition and security of the license plate.

Overview of the importance of scheduled servicing for safety and performance.

Table outlining periodic maintenance tasks and intervals.

Location and importance of vehicle identification numbers.

How to check brake pad wear.

General safety guidelines for performing maintenance.

Contents of the onboard tool kit.

Step-by-step guide to adding brake fluid.

How to adjust the free play in the brake levers.

Checking the wear of rear brake shoes.

Procedure for checking and adding engine oil.

Checking the level and for leaks in the transmission oil.

How to check tire pressure.

Instructions for removing and installing the front wheel.

Instructions for removing and installing the rear wheel.

Checks for the side stand and its related switch system.

How to inspect, clean, and replace the spark plug.

Checking the battery condition and terminals.

Procedure for checking and replacing fuses.

Instructions for replacing various bulbs on the motorcycle.

Maintenance and care for protective rubber parts on cables.

How to inspect and clean the air cleaner element.

Important precautions to take when washing the motorcycle.

Steps for preparing the motorcycle for extended storage.

Procedures for bringing the motorcycle back into use after storage.

Essential checks and preparations before riding.

Guidance on achieving an optimal riding posture.

Safety rules and considerations during operation.

Steps and precautions for starting the motorcycle.

Explains forces involved in turning and how speed affects dynamics.

Describes lean-with, lean-in, and lean-out techniques for turning.

Safety advice related to vehicle turning.

How friction affects braking and the effect of inertia.

Compares braking distances using different brake methods.

Explains impact forces during collisions.

Electrical schematic for European models.

Electrical schematic for domestic models.