Daewoo B25S-2 Disassembly/Assembly

Vehicle Systems Disassembly & Assembly
9. Remove seal (11) from the spacer.
10. Remove O-ring seal (12) and back-up ring (13)
from the head.
11. Remove seals (14), (15), and (16) from the head.
NOTE: Use the following steps to assemble the tilt
cylinder.
12. Install seal (14) in the head. Position the lip of
the seal toward the inside of the head.
13. Install seal (15).
14. Install seal (16) in the cylinder head. Position the
lip of seal (16) toward the outside of the cylinder
head.
NOTE: The curved side of back up ring (13) should
contact O-ring seal (12).
15. Install O-ring seal (12) and back-up ring (13).
Make sure the curved side of back-up ring (13) is
in contact with O-ring seal (12).
37
IDCD253P
IDCD425P
IDCD426P
11
12
13
IDCD425P
12
13
14
15
16
IDCD426P
14
15
16

Daewoo B25S-2 Specifications

General

Brand	Daewoo
Model	B25S-2
Category	Multi Terrain Loaders
Language	English