Fan Speed/Child Lock
• Touch the Fan Speed/Child Lock button (12) to change the fan speed from low
to high or high to low. The appropriate Fan Speed Indicators (17) will illuminate
to show the fan speed selected.
• To operate the Child Lock, touch and hold the Fan Speed/Child Lock button (12)
for 5 seconds.
• The unit will emit a short beep and Child Lock Indicator (16) will illuminate; the
control buttons will go out indicating that the unit cannot be operated.
• To disable the Child Lock, press and hold the Fan Speed/Child Lock button (12)
for 5 seconds, the unit will emit a short beep and the control buttons will
illuminate indicating that normal operation has been restored.
Setting the Humidity Level
• The set humidity level can be changed by touching the Humidity button (13),
the level can be set from 20 to 95%.
• The set humidity will be shown on the Digital Display (20) for a short time
before returning to show the actual humidity level.
• The unit will turn on and off to maintain the set humidity level, this is quite
normal.
Sleep
• Touch the Sleep button (14) until the button illuminates.
• The Sleep button (14), Humidity button (13) and Low Fan Speed LED indicator
(17) on the Control Panel (3) will dim.
• The fan speed will also automatically switch to low speed. Note that the fan
speed cannot be adjusted in Sleep Mode.
• To ‘wake’ the unit up touch any button on the Control Panel (3), touch the
Sleep button (14) again to exit the sleep mode.
Using the Timer
• With every touch of the Timer button (15) The timer can be set in 1 hour
increments, the time can be set from 1 hour up to 24 hours.
• The Timer button (15) will illuminate when touched.
• The time will be shown on the LED Display (20). The set time will show as “07”
for 7 hours, etc.
• If the Timer is set with the unit on, the Timer will turn the Dehumidifier off at the
end of the set time.
• If the Timer is set with the unit off, the Timer will turn the Dehumidifier on at the
end of the set time.
• To cancel the timer, press the Timer Button (15) until the LED Display (15)
returns to “00”.
To Next Page
Loading...
