Water Tank Full Alarm
When the Water Tank (7) is full, the unit will buzz and the Tank Full Indicator (18)
will illuminate.
Empty the Water Tank as follows:
a. Grasp the indent at base of the Water
Tank (7) and pull the tank free from
the dehumidifier.
b. Remove the lid from the Water Tank (7) and
empty.
c. Replace the lid back on the Water Tank (7) and
slide the tank back into the dehumidifier.
DO NOT use the Dehumidifier without the Water
Tank (7) fitted.
Continuous drainage
If preferred, continuous drainage can be used with the appliance rather than
emptying the Water Tank (7).
For this option:
• Remove the Water Tank (7) as described above.
• Fit Drain Hose (9) to the Drain Outlet (6) on the
rear of the Dehumidifier, arrowed right.
• Replace the Water Tank (7) ensuring that
the hose fits through the groove in the tank
body.
• Run the hose into a suitable drainage point
ensuring that the hose is not kinked or
bent causing a blockage.
• The hose should always be lower than the
Drain Outlet (6) to allow the dehumidifier
to drain correctly.
To Next Page
Loading...
