1. Insert the Small Power Plug (15) of the Mains Charger (16) into the Charging
Socket (6).
2. Plug the Mains Charger (16) into the nearest mains socket.
3. The Charging/Battery Indicators (5) will light in the sequence as in a, b, c below
to show the internal battery is charging.
4. Once the battery is fully charged (after approximately 5 hours), the
Charging/Battery Indicators (5) will all light as in ‘c’ below showing that the
internal battery is fully charged and the Mains Charger (16) can be removed.
The Charging/Battery Indicators will go out one at a time during use, when
none of the indicators are illuminated the internal battery will need recharging.
Attaching the Accessories
CAUTION Ensure that the vacuum cleaner is not connected to the mains charger
before use.
Fitting the Motorised Floor Tool
1. Push the Aluminium Tube (17) onto the Air/Dust Inlet (1) until it clicks home
as shown below:
2. Push the Motorised Floor Tool (13) onto the other end of the Aluminium
Tube (17) again until it clicks home.
To Next Page
Loading...
