The hydraulic system has hydraulic oil tank (10)
which holds the oil for gear type hydraulic pump (15).
Hydraulic pump (15) sends pressure oil to the power
brakes (if equipped), hydraulic and steering systems.
Pump oil flows from pump (15) to priority valve (11)
where the oil folw divides to the power brakes brake
valve (if equipped)(not shown) through line (12) and
to the steering gear through line (16).
The control valve levers move the valve spools in
control valve (5) to let the pump oil in the control
valve go to lift cylinders (1) and/or (19), tilt cylinders
(6) or sideshift cylinder(s) (3).
The return hydraulic oil from the cylinders flows
through hydraulic control valve (4), line (13), into filter
(9) and hydraulic tank (10). Relief valve (7) in the
control valve body will make the flow control valve
release extra pressure to the hydraulic tank when the
pressure in the lift or tilt circuits goes higher than
relief valve pressure shown in the Control Valve
section of Specifications. Relief valve (8) does the
same thing for the sideshift circuit when it goes
higher than the auxiliary relief valve pressure shown
in the Control Valve section of Specifications.
7 of 29New Hydraulic Systems Systems Operation
To Next Page
Loading...
Need help?
General
