- 83 -
Maintenance Section
Fuel Filters - Check, Clean,
Change
Diesel Engine-Change Filter Element
Park the lift truck with the forks lowered, parking
brake applied, transmission in neutral, engine
stopped and cool.
1. Raise the hood and seat assembly.Make sure
the hood support latch is engaged in the bracket.
Fuel leaked or spilled onto hot surfaces or
electrical components can cause a fire.
Turn the disconnect switch OFF or disconnect
the battery when changing fuel filters.
2. Loosen the plug (1) and remove cartridge (12)
from head.
3. Fill up clean fuel to the new cartridge.
4. Replace the rubber packing and smear clean
fuel to the rubber packing.
5.
Install new cartridge and remove an air in the fil-
ter with a feed pump
.
LP-Gas and Dual Fuel Engines - Clean,
Replace
Park the lift truck in an authorized refueling area
with the forks lowered, parking brake applied and
the transmission in NEUTRAL.
1. Close the fuel shutoff valve on the LP-Gas
tank. Run the engine until fuel in the line runs out
and the engine stops. Turn off the ignition switch
and disconnect switch (if equipped).
2. Scribe an line across the filter housing covers.
3. Remove the cover retaining screws.
To Next Page
Loading...
Need help?
General
