Fit the belt guards and tighten the nuts (A) nger tights. Wiggle the blade guard (E) up and down 3-5
limes, and then lighten the nuts (A) with the combination spanner.
Carburettor
The carburettor is equipped with xed needles to ensure the machine always receives the correct
mix1ure of fuel and air. When the engine lacks power or accelerates
poorly, do the following:
- Check the air lter and replace if necessary. When this does not help, contact an authorised servi-
ce workshop.
Adjusting the idle speed
Start the engine and check the idling setting. When the carburettor is set correctly the cutting blade
should be still while engine is idling.
- Adjust the idle speed using the T screw. When an adjustment is necessary, rst turn the screw
clockwise until the blade starts to rotate. Now turn the screw anti-clockwise until the blade stops
rotating.
Rec. idle speed: 3000±300 rpm
CAUTION! Contact your dealer/service workshop, if the idle setting cannot be
adjusted so that the blades are stationary. Do not use the machine until
it has been properly adjusted or repaired.
35
To Next Page