49
Oil change
• The motor oil change should be completed annu-ally
before the start of the season while the motor is at operating
temperature and shut off.
• Only use motor oil (SAE 30).
• Position the lawnmower on a straight, level surface.
• Remove the ignition key (10)
• Clean the area around the oil dipstick.
• Slowly unscrew and remove the oil dipstick.
• Place an oil pan (or suitable container) under the oil drain
bolt.
• Remove the oil drain bolt and allow the oil to drain.
• After the oil has drained completely, replace the oil drain
bolt.
• Rell the oil as described .
• Replace the oil dipstick and hand-tighten.
• Clean up any spilled oil.
• Dispose of the used oil in accordance with applicable
regulations.
To Next Page
Loading...
