Daewoo DDW-M1212 - Inlet water can not stop, unless the electricity is off; Not much water fill in; The dishwasher works when the door is open; The motor sounds but can not operate or spin

27
13.3 Capacitor malfunction Replace the capacitor
13.4 Motor axis is stick totally Replace the motor
14
W
ashing cycle
does not stop
14.1 Controller malfunction Replace it
15
Heating pipe fuse
damage
15.1
Water drain up Make sure water drain up
15.2
Sump or filter is blocked Clean the sump or filter
15.3
Suds leak out Refer to the user manual
15.4
Not much water fill Refer to “not much water fill”
15.5
Thermostat switch malfunction Replace it
15.6
Wiring malfunction or damage Maintenance
15.7
Micro switch malfunction Replace it
15.8
Base buoy malfunction or is too dirty Replace or clean the base buoy
15.9
Controller malfunction Replace it
16 Water siphon
16.1 Drain pipe opening is too low Set the opening at a suitable height
16.2 No air gap
Install an air intake at the top of the
pipe
17
Spots left on the
dishes
17.1 Use soft water (natural or man-made) Have water analyzed at related office
18
Spots and bluish
film on the glasses
18.1
Detergent stays too long in the
dispenser or too much detergent used
Please refer to the user manual and
use the dishwasher properly
18.2 Dishes are not loaded properly
18.3
The soil left in the dishwasher is not
disposed properly
Please refer to the user manual
19
Motor pump
assembly make
noise
19.1 Soil left on the sump bottom
C
lean the sump and the space around
it
19.2
Failed to install the pump assembly
correctly
C
heck the pump and install it in the
right way
19.3
Pump impeller can not fill the gap, or
friction happens
Use deployed tool to install the
filling gasket in the right place
20
Poor washing
effect
20.1 The sump or filter is blocked Clean the sump or filter
20.2 The position of the filter is not right Maintain or replace the filter
20.3
Plates or other dishes stop the spray
arm
Turn the spray arm before washing
starts
20.4
Dishes are not loaded properly
Please refer to the user manual and
use the dishwasher properly
20.5
Not enough detergent
20.6
N
ot suitable washing cycle is
selected
20.7
Detergent dispenser malfunction Replace it
20.8
Spray arm malfunction Clean or replace it
20.9
Not much water fill in Refer to malfunction 2
20.10
Pump malfunction Replace it
20.11
No salt in the water softener Refill the salt
21 Poor drying effect
21.1 Dishes are not loaded properly
Please refer to the user manual and
load the dishes properly
21.2
N
ot suitable washing cycle is
selected
21.3
Dispenser not working Replace it
21.4
The temperature of the rinsing water
is not high enough
Replace the controller
21.5 Replace the NTC thermistor