20
IMPORTANT
Change the loop handle to the J-handle for safe operation.
STARTING THE ENGINE
Please refer to 4. For sale operation , 7. Operation.
WARNING
The product is equipped with a centrifuga! clutch mechanlsm, so the
cuttlng attachment beglns to rotate as soon as the engine is started by
putting the throttle into the start position. When starting the engine,
place the product onto the ground in a flat clear area and hold it firmly in
place to ensure that neither the cutting part nor the throttle come into
contact with any obstacle when the engine starts.
CUTTING METHOD
a) Use the front left side cutting.
b) Guide the blade from your right to left with it tilted slightly to your left.
c) When mowing a wide area, start working from your left end to avoid
interference of cut grass.
d) The blade may be seized by weeds if the engine speed is too low, or the
blade cuts too deep into weeds. Adjust the engine speed and cutting depth
according to the condition of object.
WARNING
lf the grass or other object gets caught in the blade, or if the unit starts
to shake or vibrate, turn off the engine and check the whole unit. Change
the blade if it has been damaged.
Turn off the engine and make sure the blade has completely stopped
before checking the blade, and removing any object got caught In.
1. Check the bolt to lasten the blade and be sure the bolt has no fault, and
no abrasion.
2. Be sure that the blade and the holder have been fastened according to
instruction and that the blade turns smoothly without abnormal noise.
WARNING
The rotating parts fastened incorrectly may cause serlous accldent to
the operator. Make sure that the blade is not bent, warped, cracked,
broken or damaged. lf you find any error to the blade, discard it and
replace with a new one, which is certified by your supplier.
By using the shoulder strap, hang the unit on your right side. Adjust the
strap length so that the cutting head may become parallel to the ground.
To Next Page
Loading...
