6
USING THE PRODUCT
IMPORTANT
Cut only materials recommended by the manufacturer. And use only for
tasks explained in the manual.
1. Grip the handles firmly with both hands using your whole hand. Place
your feet slightly apart (slightly further apart than the width of your shoul-
ders) so that your weight is distributed evenly across both legs, and always
be sure to maintain a steady, even posture while working.
2. Keep cutting attachment below waist level.
3. Maintain the speed of the engine at the level required to perform cutting
work, and never raise the speed of the engine above the level necessary.
4. lf the unit starts to shake or vibrate, turn off the engine and check the
whole unit. Do not use it until the trouble has been properly corrected.
5. Keep all parts of your body away from rotating cutting attachment and
hot surfaces.
6. Never touch the muffler, spark plug, or other metallic parts of the engine
while the engine is in operation or immediately alter shutting down the
engine. Doing so could result in serious burns or electrical shock.
7. Never operate the pruner at an angle greater than 60 in order to reduce
the risk of being struck by falling objects during operation.
WARNING!
Approachlng or contactlng electric power lines with pruning saw may cause
serious injury or death from electrocution.
Electricity can jump from one point to another by means of arcing or may be
conducted through damp branches. Maintain a clearance of at least 15m
between Pole saw and any electrlcal llne carrying live current.
IF SOMEONE COMES
1. Guard against hazardous situations at all times. Warn adults to keep pets
and children away from the area. Be careful if you are approached. lnjury
may result from flying debris.
2. lf someone calls out or otherwise interrupts you while working, always be
sure to turn off the engine befare turning around.
MAINTENANCE
1. In arder to maintain your product in proper working arder, perform the
maintenance and checking operations described in the manual at regular
intervals.
2. Always be sure to turn off the engine and disconnect the spark plug wire
befare perfarming any maintenance or checking procedures.
To Next Page
Loading...
