ALIGNMENT INSTRUCTIONS
1. SERVICE MODE ADJUSTMENTS
Follow the steps below whenever service adjustment is required. See Table-A.
and Table-B to determine if service adjustments are required.
1)How to enter the service mode using the user remote control.
w
Turn the set on.
w
Direct the remote control to the reception window of your TV/VCR
w
Push buttons of remote control in sequence as follows.
1
Z
MUTE
Z
RECALL
Z
MUTE
w
Then, the screen will appear as follows.
w
Using the channel up ( s ) or down ( t ) buttons, select the item you wish to adjust..
The curser (
U
) move you wish to adjust item.
w
Using the volume up (
U
) or down(
) buttons to enter in the sevice mode you wish to adjust.
w
You adjust the values of service mode, automatically save to EEPROM
Table-A : Adjust the values of service mode when a part is replaced
PART
REPLACE
ADJUSTMENT
NOTE
NECESSARY UNNECESSARY
ICS01
(TIMER/SYSCON)
O Data is stored in IS03(EEPROM)
I501
(TV CHROMA)
O
IS03
(EEPROM)
O
Initial setting values are written from ICS01
Adjusting Items
S5:IFC, S6:GEO, S8:W/B, S9:DP, S11:PG Adjust
CRT O
Adjusting Items
S2:SCRN, S6:GEO, S8:W/B, S9:DP
VCR DECK
(DRN-7203)
O
Adjusting Items related to VCR DECK only.
S10:ATK OFF, S11:PG Adjust
ICY01
(VCR Y/C)
O
U
S2
S5
S6
S8
S9
S10
S11
S12
FIELE SVC
SCRN
IFC
GEO
W/B
DP
ATK OFF
PG Adjust
FACT
8
To Next Page
Loading...
Need help?
General
