EasyManua.ls Logo

Daewoo DW-160C - Precautions When Operating; Electric Connection; Cautions

Daewoo DW-160C
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
■ Be sure that the washer is grounded.
To avoid electrical shock, use a metal pipe for the ground
connection.
But, do not ground the washer with gas pipes or telephone
lines to avoid dangers of explosion or lightning strike.
■ Do not put your hands into the spin dryer
basket when it is spinning.
Your fingers can be caught by spinning laundry and
damaged.
■ Never allow children to operate or play
with the washer.
Children playing with the washer may accidentally fall into
the washing tub.
■ Disconnect the power cord from the power
supply when not in use.
■ Ventilation
openings must not be obstructed by
carpeting when the washing machine is installed on a
carpeted floor.
■ Turn off the SPIN Timer immediately when the
spin dryer makes noise and vibration excessively during
spinning.
■
Put the wash door on washing machine when
you wash laundries. It is possible to over flow if
wash door is not put on wash machine.
;
;
;
CAUTIONS
;
;
;
■ Don’t use excessively hot water.
(Below 50°C)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
■ Before washing, check all pockets.
If nails or pins remain in pockets, they may damage the
washer or clothes.
■ Close the water tap a little if the water
pressure is too high.
■ Be sure to cover with the safety cover on
laundry before spinning.
This prevents laundry from being tossed out and damaged.
■ To avoid water splashes, close the wash
door.
■ Maintain water pressure under 1kg/cm
2
during water feeding and spinning. It is
possible to overflow under high pressure.
■ Do not use overflow rinse when the laundry
weight more than 3kg, because the water
may flow over the wash tub.
PRECAUTIONS WHEN OPERATING
;
;
;
■ Make sure that electric connector is set for your
available voltage before operating the washing machine.
■ This unit is set for 220V. (~240V)
■ If you want to change the voltage, remove the back cover
and reset the connector as figures.
ELECTRIC CONNECTION
(ONLY FOR DUAL VOLTAGE MODEL)