EasyManua.ls Logo

Daewoo DW-6834 - Precautions When Operating; Electric Connection

Daewoo DW-6834
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Be sure that the washer is grounded.
To avoid electrical shock, use a metal pipe for the ground
connection.
But, do not ground the washer with gas pipes or telephone
lines to avoid dangers of explosion or lightning strike.
Do not put your hands into the spin dryer
basket when it is spinning.
Your fingers can be caught by spinning laundry and
damaged.
Never allow children to operate or play
with the washer.
Children playing with the washer may accidentally fall into
the washing tub.
Disconnect the power cord from the power
supply when not in use.
Ventilation
openings must not be obstructed by
carpeting when the washing machine is installed on a
carpeted floor.
Turn off the SPIN Timer immediately when the
spin dryer makes noise and vibration excessively during
spinning.
Put the wash tub lid on washing machine when
you wash laundries. It is possible to over flow if
wash tub lid is not put on wash machine.
;
;
;
CAUTIONS
;
;
;
Don’t use excessively hot water.
(Below 50°C)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
Before washing, check all pockets.
If nails or pins remain in pockets, they may damage the
washer or clothes.
Close the water tap a little if the water
pressure is too high.
Be sure to cover with the safety cover on
laundry before spinning.
This prevents laundry from being tossed out and damaged.
To avoid water splashes, close the wash
tub lid.
Maintain water pressure under 1kg/cm
2
during water feeding and spinning. It is
possible to overflow under high pressure.
Do not use overflow rinse when the laundry
weight more than 3kg, because the water
may flow over the wash tub.
PRECAUTIONS WHEN OPERATING
;
;
;
Make sure that electric connector is set for your
available voltage before operating the washing machine.
This unit is set for 220V. (~240V)
If you want to change the voltage, remove the back cover
and reset the connector as figures.
ELECTRIC CONNECTION
(ONLY FOR DUAL VOLTAGE MODEL)
DW-6834(¿ )-Western 01.3.26 9:30 PM ˘`3

Related product manuals