30
4. ERROR DISPLAY
ERROR
SINGAL
ERROR CAUSE COUNTERPLAN
1
inlet valve broken Change the Inlet-Valve
IE
WATER
2
drain motor working during water supply Change the Drain Motor
INLET ERROR
3
pressure switch disorder Change the Sensor Pressure
4
PCB can not check water level Change the PCB
1
drain motor out of order Change the Drain Motor
OE
DRAIN
2
inlet valve working during drain Change the Inlet-Valve
ERROR
3
pressure switch disorder Change the Sensor Pressure
4
PCB can not check water level Change the PCB
UE UNBALANCE ERROR
1
laundry unbalance rearrange the laundry
1
door opened during processing Clode the Door
LE
DOOR
2
LOCK S/W broken Change the LOCK SW
OPEN ERROR
3
PCB can not check door lock Change the PCB
1
continuous water supply Change the Inlet-Valve
E2 Overflow
2
drain motor can not work Change the Drain Motor
3
pressure switch disorder Change the Sensor Pressure
E3
FAN MOTOR
1
fan motor cannot work Change the Fan-Motor
disorder
2
PCB cannot control fan motor
The contact of the Connector or Change the PCB
E9
SENSOR PRESSURE
1
abnormal water level Change the Sensor Pressure
ERROR
1
huge noise re-installation
E5
HIGH VOLTAGE
2
spining with jamming clothes between gasket rearrange the laundry
ERROR
3
PCB broken Change the PCB
1
huge noise re-installation
E6 EMG ERROR
2
spining with jamming clothes between gasket rearrange the laundry
3
motor broken Change the Motor
4
PCB broken Change the PCB
E7 Direction Error
1
move opposite direction
2
motor Hall IC broken check the connector and change
E8 motor disorder
1
connector problem The contact of the Connector
2
abnormal loading condition check the loading condition and change
H1
sensor temp.
1
sensor temp broken Change the Sensor Temp.
dry disorder
2
connector problem The contact of the Connector
H2
sensor temp.
1
sensor temp. of washing broken Change the Sensor Temp.
wash disorder
2
connector problem The contact of the Connector
H3
overheating
1
fan motor cannot move Change the Fan Motor
dry heater
2
sensor temp. of dry broken Change the Sensor Temp.
H4
overheating
1
heater working with no water supply check water level
wash heater
2
sensor temp. of wash broken Change the Sensor Temp.
H6 abnormal of washing heater
1
washing heater cannot work Change the Heater Wash
H7 abnormal of drying heater
1
dry heater cannot work Change the Heater Dry
H8
abnormal of sensor temp.
1
heater working with no water supply
check the water level and washing heater
of washing
PEF Pump Filter
1
The drain filter is clogged. Clean the drain filter
To Next Page
Loading...
Need help?
General
