To Next PageTo Next Page
Need help?Do you have a question about the Daewoo DWC-UD121DC and is the answer not in the manual?
List of parts for the front panel assembly, including outer and inner panels, buttons, and display components.
Test mode for checking PCB and electronic parts without water supply to verify functionality.
Continuous testing mode for checking all functions and sensors sequentially without interruption.
Error related to insufficient water supply or failure to reach designated water level within the specified time.
Error indicating failure to drain water or reach the reset point after drainage starts.
Error occurring when spin-drying is not balanced or fails during the process, affecting drum stability.
Error indicating high DC-link voltage to the IPM, possibly causing motor stoppage.
Error related to high current detected at the EMG port, leading to motor stoppage.
Error when the washing temperature sensor is defective or not properly connected.
Error for incorrect water temperature during wool or delicate wash cycles.
Error indicating an abnormality or failure in the washing heater's operation.
Error occurring when the washing heater overheats without water present.
Troubleshooting steps for the heater system during the dry cycle, addressing heating failures.
Troubleshooting guide for the thermistor sensing air temperature, including open/short conditions.
Troubleshooting procedure for the fuse that protects against overheating, checking for cut-off conditions.
Identifies causes for clothes remaining wet after the drying cycle, such as overloading or poor air circulation.
Describes causes for clothes being wet and hot after drying, often related to spin performance or imbalances.
Lists potential issues when the PCB displays "H1" or "H3" error codes, often related to the thermistor.
General