Daewoo DWC-LU1011 - 3. Main Function of PCB Program; 3-1. LOAD SENSING; 3-2. Balance Spin

3939
2-3. Spin Sequence
1) Drain
① It follows Drainage Sequence.
2) Balance Spin
① If Unbalance Check pass, Start R-Spin.
② B-Spin is Until Unbalance check section, 350 r.p.m
3) R(Real) Spin
① From end of B-Spin to end of Spin Sequence is R Spin.
② r.p.m is affected by sequence
4) Shoes Spin
① Balace Spin does not work.
2-4. End
1) Crease Care
① Crease Care is process of removal laundry that stick to drum. It works 30sec ,after Spin Sequence.
② Wool and Shoes course don't work crease care
2) End
① After 10 sec power off ,alamed END.
② If drying sequence added, drying sequence works.
③ After END , door unlock.