To Next PageTo Next PageWhat to do if water does not enter my Daewoo Washer or enters slowly?
If water isn't entering your Daewoo Washer properly, first check if the water supply is adequate by checking another tap. Ensure the water supply tap is fully open and that the water inlet hose isn't kinked. Also, inspect the filter of the water inlet for clogs.
How to fix a Daewoo DWD-GN123 that won't spin?
If your Daewoo Washer won't spin, ensure the door is firmly shut. Close the door and press the Start/Pause button. Note that after pressing the button, it may take a few moments before the washer begins to spin, as the door must lock first.
What to do if my Daewoo Washer door does not open?
If the door of your Daewoo Washer won't open, wait two minutes after the wash cycle has ended. This allows the electric locking mechanism time to release for safety reasons.
How to fix IE WATER INLET ERROR on Daewoo DWD-GN123 Washer?
To fix an IE WATER INLET ERROR on your Daewoo Washer: - Open the water tap. - Clean the filter of the valve inlet. - Change the valve inlet. - Change the water level sensor (sensor pressure). - Change the drain motor. - Change the PCB ASS?Y.
How to fix UE UNBALANCE ERROR on Daewoo DWD-GN123?
If your Daewoo Washer displays a UE UNBALANCE ERROR, it means the laundry is concentrated on one side of the drum during the spin cycle. To fix this, simply rearrange the laundry inside the drum.
How to fix E8 MOTOR ERROR on Daewoo DWD-GN123 Washer?
To fix an E8 MOTOR ERROR on your Daewoo Washer: - Check the connector of the motor to ensure it is properly connected. - Change the motor if it is not working.
How to fix E5 HIGH VOLTAGE ERROR on Daewoo DWD-GN123?
To fix an E5 HIGH VOLTAGE ERROR on your Daewoo Washer: - Rearrange the laundry if it's jammed between the gasket and the drum. - Change the PCB ASS?Y.
How to fix E6 EMG ERROR on Daewoo Washer?
To resolve an E6 EMG ERROR on your Daewoo Washer: - Rearrange the laundry if it is jammed between the gasket and the drum. - Change the motor. - Change the PCB ASS?Y.
Why is my Daewoo DWD-GN123 making a thumping sound?
A thumping sound in your Daewoo Washer might be normal if you're washing a heavy load. However, if the sound continues, it could mean the washer is out of balance. Stop the washer and redistribute the wash load.
Why is my Daewoo DWD-GN123 Washer making a vibrating noise?
Ensure all transit bolts and packing have been removed from your Daewoo Washer. If not, refer to the installation guide. Also, check that all the feet are resting firmly on the ground. An unevenly distributed wash load can also cause vibration, so stop the washer and rearrange the load.
Protects the appliance from damage during transport.
Instructions for removing transit bolts before operation.
Guidelines for selecting a suitable installation location for the washer.
Electrical safety information for UK plugs and wiring.
Procedure for connecting the water inlet hose to the tap and washer.
How to adjust the washing machine legs for stability and reduced vibration.
Explanation of control panel functions for DWD-HB143**/HC123** models.
Explanation of control panel functions for DWD-HB144**/HC124** models.
Wiring diagram for the DD motor type washing machine.
Wiring diagram for the universal motor type washing machine.
General
